This Article Full Text (PDF) References Alert me when this article is cited Alert me if a correction is posted Citation Map Services Email this article to a friend Similar articles in this journal Alert me to new issues of the journal Add to Saved Citations Download to citation manager Request Permissions Request Reprints Add to My Marked Citations Citing Articles Citing Articles via HighWire Citing Articles via Google Scholar Citing Articles via Scopus Google Scholar Articles by Newbury, K. M. Articles by Leo, D. J. Search for Related Content Social Bookmarking                         What's this?

Electromechanical Modeling and Characterization of Ionic Polymer Benders

Donald J. Leo

Center for Intelligent Material Systems and Structures, Mechanical Engineering Department, Virginia Polytechnic Institute and State University, Blacksburg, VA, USA

This paper presents a coupled, electromechanical model of a Nafion-based ionic polymer transducer used in the cantilevered bender configuration. A comparison of simulatedandexperimental responses for a 0.2 mm 5.0 mm 17 mm actuator validates both the form of the model and the empirically determined model parameters. In one of the experiments used for parameter identification, the short circuit current is found to be proportional to the induced actuator velocity, with the constant of proportionality on the order of 10⁴A/(m/s). This dynamic model differs from those presented by other researchers in that it is able to represent the transducer as either a sensor or as an actuator. Also presented is an assessment of the polymer actuators’ ability to perform mechanical work. The results of a series of force versus deflection experiments are outlined, and energy densities are calculated to facilitate comparison with other actuator technologies. The maximum blockedforce with a 1.25 V step input was 1.6 mN (with a 17 mm actuator), andthe maximum free deflection with a 1.25 V step input was 1.8 mm (with a 22 mm actuator). The energy densities ranged from 1.1 to 12.8 mJ/kg and3.4E-06 to 4.0E-05 mJ/mm³ with an input range of 0.75–1.25 V.

Journal of Intelligent Material Systems and Structures, Vol. 13, No. 1, 51-60 (2002)
DOI: 10.1177/1045389X02013001978


CiteULike    Complore    Connotea    Del.icio.us    Digg    Reddit    Technorati    Twitter    What's this?

This article has been cited by other articles:

				C. S. Kothera, D. J. Leo, and S. L. Lacy Characterization and Modeling of the Nonlinear Response of Ionic Polymer Actuators Journal of Vibration and Control, August 1, 2008; 14(8): 1151 - 1173. [Abstract] [PDF]

				C. S. Kothera and D. J. Leo Identification of the Nonlinear Response of Ionic Polymer Actuators using the Volterra Series Journal of Vibration and Control, April 1, 2005; 11(4): 519 - 541. [Abstract] [PDF]

				C. S. Kothera and D. J. Leo Bandwidth Characterization in the Micropositioning of Ionic Polymer Actuators Journal of Intelligent Material Systems and Structures, January 1, 2005; 16(1): 3 - 13. [Abstract] [PDF]

				D. J. Leo, C. Kothera, and K. Farinholt Constitutive Equations for an Induced-Strain Bending Actuator with a Variable Substrate Journal of Intelligent Material Systems and Structures, November 1, 2003; 14(11): 707 - 718. [Abstract] [PDF]

				K. M. Newbury and D. J. Leo Linear Electromechanical Model of Ionic Polymer Transducers -Part I: Model Development Journal of Intelligent Material Systems and Structures, June 1, 2003; 14(6): 333 - 342. [Abstract] [PDF]